Pin 1
GND
Pin 2
+12VDC
Pin 4
Bill Acceptor pulse
Pin 5
Push Button pulse
Pin 6
Empty RED LED.
NOTE: must run a wire from (P3, Pin 2) to P1, Pin 6.
When Empty Switch grounds, the Red LED comes ON.
Pin 7
LED power +12VDC through a 1K resistor
Pin 8
6 digit Mechanical Meter (+12VDC) using Pin 9 w/o diode
Pin 9
+12VDC w/o 1K resistor
Pin 10
Ready LED (Green) side of BI-color
INFORMATION NOTES:
If any one of
the four following conditions occurs, the Green LED will be turned OFF.
1. Empty Sensor
2. Busy (in dispense cycle)
3. Sensor 2
4.
Jammed
The Red LED is turned ON when the Empty Sensor Switch
indicates empty. The LED can
flicker if the switch is bouncing.
The card is always HELD.
The # retries for a jam is set to 7.
DIP SWITCHES:
A VERSION DIP SWITCHES:
sw 1 - 4 "off" = $0
sw 1 "on" = $1
sw 2 "on" = $2
sw 3 "on" = $4
sw 4 "on" = $8
|
B VERSION DIP SWITCHES:
sw 1 - 4 "off" = $0
sw 1 "on" = $1
sw 2 "on" = $5
sw 3 "on" = $10
sw 4 "on" = $20
|
C VERSION DIP SWITCHES:
sw 1 - 4 "off" = $0
sw 1 "on" = $5
sw 2 "on" = $10
sw 3 "on" = $20
sw 4 "on" = $40
|
The version number firmware is: A or B or C
[ END OF DOCUMENT ]